RECOMMENDED STUDY OF EXTINGUISHING METHODS BASED ON THE 1994 PETTIFER AND FOOKES CRITERIA APPROACH TO THE PLANNING OF THE TRANS-PAPUA WASIOR-NABIRE ROAD
STUDI REKOMENDASI METODE PENGGALIAN BERDASARKAN PENDEKATAN KRITERIA PETTIFER DAN FOOKES 1994 PADA PERENCANAAN RUAS JALAN TRANS PAPUA WASIOR-NABIRE
Abstract
The road is one of the traffic infrastructures for driving which supports all community activities. One of the stages of road construction is land clearing, in which one of the activities is eviction or excavation. The road construction location is the Trans Papua Wasior-Nabire road, Yamor District, Kaimana Regency, West Papua Province. However, the problem in this study is whether the excavation method is suitable for excavating material for road construction. Based on these problems, the purpose of this study is to recommend a method of excavation on the Trans Papua Wasior-Nabire road section. The method used is the Pettifer and Fookes (1994) criterion approach to determine the capability method. The results obtained with this approach indicate that the KM 501+500 excavation site is included in the level of easy digging capability or enters into a condition that is easy to dig. At the KM 502+100 excavation site, it is included in the hard digging capability level or a category that is difficult to dig because of the condition of the material which is difficult to dig, so the recommendation given is to use heavy equipment, namely a hydraulic excavator (backhoe) or a power shovel.
Downloads
References
Adriansyah, Y., Krisnantara, G., & Setiadi, K. (2021, April). Korelasi Point load Index dan Uniaxial Compressive Strength Pada Satuan Batupasir dan Batulempung Formasi Latih Untuk Penentuan Koefisien Kekuatan Batuan di Pit X Tambang Batubara PT Berau Coal, Kalimantan Timur. Jurnal Geomine, Volume 9(Nomor 1), 9-16.
Bell, F. G. (2007). Engineering Geology Second Edition. London: Butterworth-Heinemann.
Brady, B. H., & Brown, E. T. (2004). Rock Mechanics for underground mining. United State: Kluwer Academic Publishers.
Dewi, L. K., Oktaviani, R., Devi, S. D., Trides, T., & Nugroho, W. (2022, Juni). Korelasi Point load Index Terhadap Uniaxial Compressive Strength Batupasir Formasi Balikpapan Kota Samarinda Provinsi Kalimantan Timur (Corelation of Point load Index towards Uniaxial Compressive Strength of Sandstone in Balikpapan Formation Samarinda Eas. Jurnal Teknologi Mineral, Volume 10(Nomor 1), 24-30.
Hasanah, N., Hakim, R. N., Santoso, E., & Melati, S. (2019, Juli). Alternatif Penentuan Uniaxial Compressive Strength Batulempung Dari Point load Strength Index Dan Rebound Number Schmidt Hammer. Jurnal GEOSAPTA, Volume 5(Nomor 2), 127-132.
Hudson, J. A., & Harrison, J. P. (1997). Engineering Rock Mechanics; An Introduction to the Principles. London: Pergamon Press.
International Society For Rock Mechanics and Rock Enginering. (1985, April). Suggested method for determining point load strength. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts, Volume 22(2), 53-60.
Kurniawan, W., & Heriyadi, B. (2018, November). Analisis Metode Penggalian Batuan Berdasarkan Kriteria Indeks Kekuatan Batu (Franklin) di Site Penambangan Batu Dolomite PT. Bakapindo, Jorong Durian, Nagari Kamang Mudiak, Kecamatan Kamang Magek, Kabupaten Agam, Provinsi Sumatera Barat. Jurnal BIna Tambang, Volume 3(Nomor 3), 1275-1284.
Musriadi, Wahyuni, A., Zelviani, S., Trihendriansyah, & Lestari, U. (2019, Juni). Struktur Batuan Penyusun Desa Pada'elo Kecamatan Mallawa Kabupaten Maros. JFT, Volume 6(Nomor 1), 80-85.
Nata, R. A., & Sabri, A. (2020, Juni). Block Punch Index (BPI) Dan Point load Index (PLI) Untuk Memprediksi Nilai Kuat Tekan Batuan Penyusun Lereng Tambang Gunna Mencegah Terjadinya Longsoran Di CV. Bara Mitra Kencana, Sawahlunto. Jurnal Sains dan Teknologi, Volume 20(Nomor 1), 65-70.
Prima, G. R., & Hafudiansyah, E. (2022, Februari). Produktivitas Alat Berat Pada Pekerjaan Proyek Jalan Tol (Studi Kasus: Ruas Jalan Tol Pematang Panggang – Kayu Agung Seksi 2, Ogan Komering Ilir, Sumatera Selatan). Jurnal Ilmiah Teknik Sipil, Volume 3(Nomor 2), 74-81.
Rai, M. A., Kramadibrata, S., & Wattimena, R. K. (2014). Mekanika Batuan. Bandung: Institut Teknologi Bandung Press.
Rusydy, I., Al-Huda, N., Fahmi, M., & Effendi, N. (2020, Juni). Analisis Modulus Deformasi Massa Batuan pada Segmen Jalan USAID Km 27 Hingga Km 30 Berdasarkan Klasifikasi Massa Batuan. RISET Geologi Pertambangan, Volume 30(Nomor 1), 93-105. doi:10.14203/risetgeotam2020.v30.1073
Sagita, P. A., & Pramana, I. P. (2022, Juli). Pengendalian Tindakan Land Clearing oleh Kesatuan Masyarakat Hukum Adat Menurut Hukum Positif di Indonesia. Jurnal Magister Hukum Udayana, Volume 11(Nomor 2), 366-379.
Syarif, A., Nurhakim, & Hakim, R. N. (2020, Januari). Perancangan Alat Uji Beban Titik Menggunakan Pressure Gauge Serta Menentukan Korelasinya Terhadap Uji Kuat Tekan Uniaksial Pada Batulanau. Jurnal GEOSAPTA, Volume 6(Nomor 1), 63-67.
Wibowo, A. (2019). Tesis; Evaluasi Kondisi Geologi Teknik dan Analisis Kestabilan Ekskavasi Terowongan Air Nanjung Provinsi Jawa Barat. Yogyakarta: Departemen Geologi Universitas Gadjah Mada.
Published
How to Cite
Issue
Section
Copyright (c) 2023 Arif Setiawan, Sampary William Wakum, Ismiyati, Louis Hermanus Lamma
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
